Kyocera TASKalfa 4501i Operation Manual page 219

Operation on the Machine > Sending
DSM Scan (Windows Server 2008 R2 or Windows Server 2012 Only)
A scanned document can be automatically saved in any format or sent to any destination by reading a scan process
from Active Directory.
NOTE
If you are performing DSM scan, check the items below.
• The machine is connected to an Active Directory on the network that the scan process can reference.
• "DSM Scan" and "LDAP" are set to [On] in
• "SSL" is set to [On] in
• [Network Authentication] is set in
If the Active Directory that the scan process can reference is not on the network authentication server, DSM must be
set in Command Center RX. For details, refer to the Command Center RX User Guide.
1
2
3
Set the type of original, file format, etc., as desired.
4
Press the [Start] key.
Sending begins and the software installed on the computer is activated.
Procedure from Your Computer
1
Press [From Computer] and press [Next].
2
Use the software installed on the computer to send the images.
Protocol Settings (page 8-45)
Security Settings (page 8-46)
User Login (page
Press [Send] on the Home screen.
NOTE
Depending on the settings, the address book screen may appear. In this event, press
[Cancel] to display the screen for sending.
Place the originals.
Loading Originals (page 5-2)
in Network.
in Network.
9-4).
Send
5-39