Table of Contents
Advertisement
Turn on and off the Océ TDS750
Turn on and off the printer
Set the On/Off switch at the rear of the printer to position "1". The green LED turns
1.
on. The message Ready to print appears on the printer operator panel.
Note:
You must separately switch on the controller via the button at the front of the printer.
Set the On/Off switch at the rear of the printer to position "0". This action only turns
2.
off the printer.
Note:
Before you turn off the printer, make sure that the printer is not printing a job.
Illustration
[17] On / Off button on the incorporated Océ TDS750 Power Logic
34
Chapter 1 - Introduction
®
Controller
Advertisement
Table of Contents
