Table of Contents
Advertisement
Auto align
1 Open the "Layout" card in the "Copy" section.
1.
[147] Automatic shift with the Align function
Press the "Align" function key and select a horizontal alignment value (Left, Center or
2.
Right) with the arrow keys.
Press the "Align" function key again and select a vertical alignment value (Top, Center,
3.
or Bottom) with the arrow keys.
Note:
If you select "Center", make sure the original width is specified as
standard" scan size' on page
"Standard" if a standard sized original is used
The exact original width (numeric) if a non-standard sized original is used.
Feed your original.
4.
Note:
You must switch on standard cut length to get output like the one in the example of the
illustration above. If Synchro cut length has been switched on, the result will be as illus-
trated below; the media is cut at the edge of the printed image.
In
'Shift the image' on page
on the page.
188
Chapter 4 - Use the Océ TDS600 scanner
176:
1
4
7
189, you can read how to define the exact place of your image
2
5
8
follows'Selecting "Non-
3
6
9
Advertisement
Table of Contents
