Enable reinforcement
1.
Access the Océ TDS750 Power Logic
Log on as key operator or repro operator.
2.
Click 'Preferences' - 'Print job defaults' - 'Finishing' - 'Binding strip'
3.
Select reinforcement to enable the reinforcement option.
4.
Note:
You can also set reinforcement on the printer operator panel in offline mode.
Set reinforcement for the copy job in the scanner operator panel of the Océ TC4
scanner
Access the Copy templates.
1.
Open the "Binding" option in the template.
2.
Select "Reinforce".
3.
Set reinforcement for the copy job in the scanner operator panel of the Océ
TDS600 scanner
Press the "Finishing" card in the "Print" section.
1.
Press the function key "Binding".
2.
Select "Reinforce".
3.
®
Controller application.
Chapter 9 - The finishing options
The reinforcement unit
323