Table of Contents
Advertisement
Note:
When you feed the original, keep it in place until it is transported (about 1 cm/0.4 in)
into the machine.
Press the green start key.
3.
Result
You do a basic copy job in 2 steps. The basic copy job uses the settings of the first template.
Steps in an extended copy job
Feed the original.
1.
Define the job settings.
2.
Select the required template at the scanner operator panel and change the predefined
settings only if necessary.
Note:
The changes you make are not stored in the template itself. You can use the Last used
template if you want to use the same settings as in the previous scan job.
Press the green start key.
3.
Result
An extended copy job takes one additional action only.
Chapter 4 - Use the Océ TDS600 scanner
Introduction to copy jobs
135
Advertisement
Table of Contents
