Table of Contents
Advertisement
Correct the settings with the correction key
Press the Correction key one time to return to the default value of the active setting.
1.
Press the Correction key two times to set the numeric display to 1.
2.
Press the Correction key three times to return to the top layer of the scanner operator
3.
panel. When the scanner templates are enabled in the Océ TDS750 Power Logic
troller application, the top layer shows the templates. When the templates are not enabled
in the Océ TDS750 Power Logic
tom" section.
When "Automatic feed" is selected for a single sheet job, this setting stays active after the
job is completed.
Job interrupt only stays active for one job. You have to press the Job interrupt key before
each new job you want to give interrupt priority.
The scanner operator panel will automatically return to the top layer and the default
settings after the time defined in the "panel time-out" setting in the Océ TDS750 Power
®
Logic
Controller application.
Settings on the scanner operator panel
®
Controller application, the top layer shows the "Cus-
Chapter 4 - Use the Océ TDS600 scanner
®
Con-
133
Advertisement
Table of Contents
