Basic Operation; Connecting Equipment; Turning The Power On/Off; Turning The Power On - Roland Studio-Capture Amplifier Owner's Manual

Basic Operation

Connecting Equipment

Connect guitars and mics to the INPUT jacks, and amplified speakers to the LINE OUT 1L and 2R
jacks . Headphones can be connected to the PHONES 1 jack and PHONE 2 jack (p . 6–p . 10) .

Turning the Power On/Off

* Before you proceed, you must install the USB driver on your computer (p . 11) .
* Once everything is properly connected (p . 6–p . 10), be sure to follow the procedure below to turn
on their power . If you turn on equipment in the wrong order, you risk causing malfunction or
equipment failure .

Turning the Power On

1.
Turn the [MONITOR OUT LEVEL] knob and [PHONES LEVEL 1] [PHONES LEVEL 2]
knobs all the way to the left .
2.
Connect the STUDIO-CAPTURE to the computer using the USB cable .
3.
Switch on the power to any external equipment connected to the input jacks .
4.
Press and hold the STUDIO-CAPTURE's [
then release it .
* This unit is equipped with a protection circuit . A brief interval (a few seconds) after turning the
unit on is required before it will operate normally .
* Before turning the unit on/off, always be sure to turn the volume down . Even with the volume
turned down, you might hear some sound when switching the unit on/off . However, this is
normal and does not indicate a malfunction .
5.
Switch on the power to your amp or powered monitor speakers .
6.
During playback, adjust the volume by turning the [MONITOR OUT LEVEL] knob and
[PHONES LEVEL 1] [PHONES LEVEL 2] knobs toward the right .
16
] (Power) button for several seconds, and