Roland Studio-Capture Amplifier Owner's Manual page 35

Reverb
You can apply reverb to the audio signal of the direct monitor in the monitor mixer A .
Setting Value
OFF
ECHO
ROOM
TYPE
SMALL HALL
LARGE HALL
PLATE
0, 0 .1, 0 .2, 0 .4, 0 .8,
PRE-
1 .6, 3 .2, 6 .4, 10,
DELAY
20, 40, 80, 160 ms
TIME 0 .1–5 .0 s
MEMO
• You can adjust the PRE-DELAY and TIME parameters for each TYPE .
• The reverb can also be controlled from the STUDIO-CAPTURE itself (p . 24) .
• Reverb is not available when operating at a sampling rate of 192 kHz .
Changing how the [SOLO] button works
You can specify complete muting or a specific level reduction for the channels other
than the soloed channel in the monitor mixer control screen .
In the STUDIO-CAPTURE Control Panel, click the "Device" menu, then click [Device
Settings] and make this setting .
Using the STUDIO-CAPTURE Control Panel
Explanation
No reverb will be applied .
Echo will be applied .
Reverb that simulates the reverberation of a room .
Reverb that simulates the reverberation of a hall; produces a more spacious
reverberation than ROOM .
Simulates plate reverberation (a reverb unit that uses the vibration of a
metallic plate) . Provides a metallic sound with a distinct upper range .
Adjusts the time from when the direct sound is output until the effect sound
is output .
Lengthening the pre-delay will create an effect in which multiple sounds are
heard .
Adjusts the time over which the reverberation decays to silence .
Value
OFF
-6
-12
-18
Explanation
The channels will be muted .
The level will decrease by -6 dB .
The level will decrease by -12 dB .
The level will decrease by -18 dB .
35