Roland Studio-Capture Amplifier Owner's Manual page 21

Using AUTO-SENS
1.
Press the [AUTO-SENS] button; it will blink .
2.
While the button is blinking, perform the loudest portion of the song .
If you decide to cancel, press the [DISPLAY] button .
3.
Stop performing .
There is no input for approximately four seconds, then the [AUTO-SENS] button will
change from rapid blinking to being unlit, and you'll exit this setting .
MEMO
If you want to change the maximum recording level setting used by AUTO-SENS,
or if you want to manually exit AUTO-SENS, you can make these changes in the
SYSTEM screen (p . 39) .
Checking the phantom power on/off status for each jack
If you press and hold the [48V] button, you'll see the
phantom power on/off status for each of the INPUT 1–12
jacks .
To switch phantom power on/off, continue holding the
[48V] button and press the corresponding input channel
button .
* This also works for the [PHASE], [LoCUT], and [COMPRESSOR] buttons .
Basic Operation
21