Roland Studio-Capture Amplifier Owner's Manual page 36

Using the STUDIO-CAPTURE Control Panel
Device panel
Here you can view the status of the STUDIO-CAPTURE's settings .
Selects which unit's mixer will be shown
when two STUDIO-CAPTURE units are
connected (p . 46) .
When you click this button, the display of
the STUDIO-CAPTURE unit itself will be
highlighted .
If you use only one unit, it showed
STUDIO-CAPTURE only .
Indicates/Sets the sampling rate .
About the sampling rate
The sampling rate setting of the STUDIO-CAPTURE automatically changes to match
the rate of the audio data that is played, or the rate that your DAW software is set to
when recording .
But you can also change the sampling rate of the STUDIO-CAPTURE manually . Click
[ ] of the SAMPLE RATE on the device panel, then select another sampling rate . In
this case, you may also need to change the sampling rate of the DAW software .
* The sampling rate cannot be changed during playback or recording, or when
equipment is connected to the COAXIAL IN (15/16) jack .
* When the sampling rate is switched, a small pop noise may be heard, but this does
not indicate a malfunction .
36
Indicates the clock source .
Setting Explanation
The STUDIO-CAPTURE's internal
INTERNAL
clock is used .
The STUDIO-CAPTURE is operating
in synchronization with the digital
EXTERNAL
signal being input to COAXIAL IN
(15/16) jack .