Roland Studio-Capture Amplifier Owner's Manual page 34

Using the STUDIO-CAPTURE Control Panel
DAW monitor A–D
Here you can control the balance of the five stereo channels of audio data sent from the computer,
and send it to the headphones or the monitoring section .
You can control the four output mixers independently .
If this is on, settings other than
PAN will be linked in stereo .
Switches mute on/off .
Switches solo on/off (refer to the
column on p . 35) .
Shows the level of the signal that
is output from the compressor .
Master A–D
Here you can control the master output levels of the direct monitor and the DAW monitor .
If this setting is on, the master
volume of the director monitor
and DAW monitor will be linked .
Display the reverb dialog (direct
monitor A only) .
Adjusts the reverb type and delay
time, etc . (p . 35) .
34
Specifies the panning of the sound .
Adjusts the monitor level of the audio
signal from the computer .
Indicates the output destination for
each monitor mixer .
* Use the patch bay (p . 37) to specify the
output destination .
Adjusts the return level to the reverb
unit (direct monitor A only) .
If this is on, the master output levels
of the left and right channels will be
linked .
Adjust the master output levels for
direct monitor and DAW monitor,
respectively .