Table of Contents
Advertisement
RRP14.9 DRIVE ASSY FEED (PL 14.3.2)
[Removal]
1)
Remove 500 SHEET FEEDER LEFT COVER. (RRP 14.6)
2)
Remove CLUTCH ASSY PH. (RRP 14.11)
When carrying out the work shown below, leave the relay connector (P/J610) of
SOLENOID FEED on the harness side.
3)
Remove connector (P/J446) on PWBA MOT (PL 14.3.11) and connector (P/J610) of SOLENOID
FEED (PL 14.3.3).
Screws to be removed in the work shown below are used to fix four corners (
DRIVE ASSY FEED, and other screws should not be removed.
4)
Remove four screws (silver, 6mm) that fix DRIVE ASSY FEED (PL 14.3.2) to 500 SHEET
FEEDER ASSEMBLY.
5)
Remove the upper right convex of DRIVE ASSY FEED from 500 SHEET FEEDER
ASSEMBLY, remove DRIVE ASSY FEED.
[Replacement]
1)
Put the convex on upper right side of DRIVE ASSY FEED (PL 14.3.2) to the notch of 500
SHEET FEEDER ASSEMBLY. Match the hole of DRIVE ASSY FEED to the boss of 500
SHEET FEEDER ASSEMBLY and attach it.
2)
Fix DRIVE ASSY FEED to 500 SHEET FEEDER ASSEMBLY using four screws (silver,
6mm).
3)
Attach connector (P/J446) on PWBA MOT (PL 14.3.11) and connector (P/J610) of SOLENOID
FEED (PL 14.3.3).
4)
Attach CLUTCH ASSY PH. (RRP 14.11)
5)
Attach 500 SHEET FEEDER LEFT COVER. (RRP 14.6)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 313
mark) of
Advertisement
Chapters
Table of Contents
