Table of Contents
Advertisement
RRP11.4 DEVELOPER ROTOR MOTOR (PL 11.1.4)
[Removal]
1)
Remove COVER ASSY RH. (RRP 1.12)
2)
Remove LEFT COVER. (RRP 1.10)
3)
Remove MULTIPURPOSE FEEDER COVER. (RRP 1.7)
4)
Remove LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
5)
Remove LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
6)
Release clamp that fixes WIRE ASSY DEVE (PL 9.1.14), remove WIRE ASSY DEVE.
7)
Remove connector (P/J433) on ROTOR CONTROL BOARD (PL 12.1.2).
8)
Remove four screws (silver, with a flange, 6mm) that fix DEVELOPER ROTOR MOTOR (PL
11.1.4) to the main unit.
9)
Remove DEVELOPER ROTOR MOTOR from the main unit.
[Replacement]
WIRE ASSY DEVE should not be caught between the main unit and DEVELOPER
ROTOR MOTOR when carrying out the work shown below.
1)
Match the boss of DEVELOPER ROTOR MOTOR to the hole of main unit and attach it.
2)
Fix DEVELOPER ROTOR MOTOR to the main unit using four screws (silver, with a flange,
6mm).
3)
Attach connector (P/J433) on ROTOR CONTROL BOARD.
4)
Fix WIRE ASSY DEVE with a clamp.
5)
Attach LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
6)
Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
7)
Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
8)
Attach LEFT COVER. (RRP 1.10)
9)
Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 269
Advertisement
Chapters
Table of Contents
