Dell 3010CN Service Manual page 354

RRP9.8 COVER ROTARY BOTTOM (PL 9.2.13)
[Replacement]
1) Align the two hooks at the left and right of COVER ROTARY BOTTOM to the holes of the
main unit, and attach COVER ROTARY BOTTOM.
2) Fix COVER ROTARY BOTTOM to the main unit using the two screws (silver, with a flange,
10mm).
3) Lay WIRE ASSY DEVE on COVER ROTARY BOTTOM, attach it.
4) Attach PWBA CRUM. (RRP 12.4)
5) Attach ROTOR CONTROL BOARD. (RRP 12.2)
6) Attach HIGH VOLTAGE POWER SUPPLY(HVPS). (RRP 12.1)
7) Attach DEVELOPER ROTOR MOTOR. (RRP 11.4)
8) Attach FRAME ASSY-ROTARY. (RRP 9.7)
9) Attach HOUSING ASSY-DEVE. (RRP 9.6)
10) Attach PHOTO SENSOR. (RRP 9.5)
11) Attach HOLDER ASSY-BIAS. (RRP 9.4)
12) Attach TONER CARTRIDGE SENSOR. (RRP 9.2)
13) Attach DEVELOPER LATCH ASSEMBLY. (RRP 9.1)
14) Attach PHOTORECEPTOR MOTOR. (RRP 11.6)
15) Attach DEVELOPMENT MOTOR. (RRP 11.5)
16) Attach IBT CLEANING DRIVE ASSEMBLY. (RRP 11.2)
17) Attach RIGHT IBT GUIDE ASSEMBLY. (RRP 7.4)
18) Attach LEFT IBT GUIDE ASSEMBLY. (RRP 7.2)
19) Attach CHASSIS ASSY ESS. (RRP 12.10)
20) Attach LOW/HIGH VOLTAGE POWER SUPPLY. (RRP 12.7)
21) Attach PWBA MCU. (RRP 12.6)
22) Attach COVER INNER L. (RRP 1.13)
23) Attach LOWER FRONT COVER and COVER FRONT-U. (RRP 1.8)
24) Attach MULTIPURPOSE FEEDER COVER. (RRP 1.7)
25) Attach LEFT COVER. (RRP 1.10)
26) Attach TOP COVER. (RRP 1.1)
27) Attach COVER ASSY RH. (RRP 1.12)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 256