Table of Contents
Advertisement
RRP6.2
SENSOR JAM 2 (PL 6.1.3)
[Removal]
1)
Remove FUSER CHUTE ASSEMBLY. (RRP 6.1)
2)
Remove two screws (silver, with a washer, tap, 8mm) that fix DIODE (PL 6.1.28) to FUSER
CHUTE ASSEMBLY (PL 6.1.1).
3)
Remove DIODE from FUSER CHUTE ASSEMBLY.
4)
Remove a screw (silver, with a washer, tap, 8mm) that fixes CHUTE-FSR (PL 6.1.4) and
PLATE DIS 2ND (PL 6.1.38) to FUSER CHUTE ASSEMBLY.
5)
Remove PLATE DIS 2ND from FUSER CHUTE ASSEMBLY.
6)
Remove CHUTE-FSR from FUSER CHUTE ASSEMBLY.
7)
Remove the connector (P/J111) of SENSOR JAM 2 (PL 6.1.3).
8)
Remove a screw (silver, tap, 6mm) that fixes SENSOR JAM 2 to FUSER CHUTE ASSEMBLY.
9)
Remove SENSOR JAM 2 from FUSER CHUTE ASSEMBLY.
[Replacement]
1)
Match the boss of SENSOR JAM 2 (PL 6.1.3) to the hole in FUSER CHUTE ASSEMBLY (PL
6.1.1), and attach SENSOR JAM 2.
2)
Fix SENSOR JAM 2 to FUSER CHUTE ASSEMBLY using a screw (silver, tap, 6mm).
3)
Attach the connector (P/J111) of SENSOR JAM 2.
4)
Match the three convex of CHUTE-FSR (PL 6.1.4) to the hole of FUSER CHUTE ASSEMBLY
and then match the hole of CHUTE-FSR to the boss of FUSER CHUTE ASSEMBLY, attach
CHUTE-FSR.
5)
Attach PLATE DIS 2ND to FUSER CHUTE ASSEMBLY.
6)
Fix CHUTE-FSR and the right side of PLATE DIS 2ND to FUSER CHUTE ASSEMBLY using
a screw (silver, with a washer, tap, 8mm).
Pay sufficient attention on the fitting direction of DIODE FUSER when carrying out the
work shown below.
Mount DIODE FUSER in a way that the white paint side of DIODE FUSER is oriented to
the side jointly fastened with CHUTE-FSR.
7)
Match DIODE (PL 6.1.28) to the concave of FUSER CHUTE ASSEMBLY and attach it.
Hold the terminal of DIODE FUSER between washer and plate at attaching when carrying
out the work shown below.
8)
Fix the right side terminal of DIODE to FUSER CHUTE ASSEMBLY using a screw (silver,
with a washer, tap, 8mm).
9)
Fix the left side terminal of DIODE and left side of CHUTE-FSR to FUSER CHUTE
ASSEMBLY using a screw (silver, with a washer, tap, 8mm) and a washer.
10) Attach FUSER CHUTE ASSEMBLY. (RRP 6.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 191
Advertisement
Chapters
Table of Contents
