Dell 3010CN Service Manual page 200

RRP3.20 SEPARATOR ASSEMBLY (PL 3.2.25)
[Replacement]
Try not to break the boss of SEPARATOR ASSEMBLY when carrying out the work shown
below.
1) Match SPRING RETARD (PL 3.2.26) to the boss of CHUTE ASSY 250, and depress the boss
part on both sides of SEPARATOR ASSEMBLY. Attach SEPARATOR ASSEMBLY to CHUTE
ASSY 250.
Check that SPRING RETARD is placed in the boss of SEPARATOR ASSEMBLY and the
boss of CHUTE ASSY 250.
Pay attention to fitting direction of LEVER 250 when carrying out the work shown below.
2) Fix the shaft on both sides of LEVER 250 by the hooks of CHUTE ASSY 250 and attach
LEVER 250.
Be sure to engage the concave of SEPARATOR ASSEMBLY with the convex of LEVER
250 properly.
Pay attention to fitting direction of BUTTON FDR 250 when carrying out the work shown
below.
3) Attach SPRING LEVER 250 to the boss of CHUTE ASSY 250 and attach BUTTON FDR 250
to CHUTE ASSY 250.
Check that SPRING LEVER 250 is placed in the boss of BUTTON FDR 250 and the boss
of CHUTE ASSY 250.
4) Attach CHUTE ASSY RETARD 250. (RRP 3.26)
5) Attach HOUSING ASSY FEED. (RRP 3.14)
6) Attach DRIVE ASSY FEED 250. (RRP 3.5)
7) Attach CLUTCH ASSY PH. (RRP 3.7)
8) Attach 250 SHEET FEEDER CHUTE ASSEMBLY.(RRP 3.3)
9) Attach 250 SHEET FEEDER RIGHT COVER. (RRP 3.4)
10) Attach 250 SHEET FEEDER LEFT COVER. (RRP 3.2)
11) Attach 250 SHEET PAPER TRAY. (RRP 2.1)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 102