Wireless Lan General Screen - ZyXEL Communications NBG4615 User Manual

Chapter 12 WISP Mode

12.5 Wireless LAN General Screen

Use this screen to configure the wireless LAN settings of your NBG4615. Go to Configuration >
Wireless LAN > General to open the following screen.
Figure 66 WISP Mode: Wireless LAN > General
The following table describes the labels in this screen.
Table 39 WISP Mode: Wireless LAN > General
LABEL
WISP Parameters
SSID
Channel
Selection
Security Mode
Apply
Cancel
12.5.0.1 No Security
Use this screen if the access point to which you want to connect does not use encryption.
Figure 67 No Security (WISP)
The following table describes the labels in this screen.
Table 40 No Security (WISP)
LABEL
WISP Parameters
SSID
Channel
Selection
Security Mode
94
DESCRIPTION
Enter the name of the access point to which you are connecting.
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices is called
a channel. The device will automatically select the channel with the least
interference.
Select the security mode of the access point to which you want to connect.
Click Apply to save your changes back to the NBG4615.
Click Cancel to reload the previous configuration for this screen.
DESCRIPTION
Enter the name of the access point to which you are connecting.
The range of radio frequencies used by IEEE 802.11b/g/n wireless devices is called
a channel. The device will automatically select the channel with the least
interference.
Select No Security in this field.
NBG4615 User's Guide