What You Need To Know; Setting Your Nbg4615 To Universal Repeater Mode - ZyXEL Communications NBG4615 User Manual

Chapter 11 Universal Repeater Mode

11.3 What You Need to Know

With the exception of the Wireless LAN > AP Client screen, other configuration screens in
Universal Repeater mode are similar to the ones in Access Point Mode. See
through Chapter 29 on page 221

11.4 Setting your NBG4615 to Universal Repeater Mode

Connect your computer to the LAN port of the NBG4615.
1
The default IP address of the NBG4615 is "192.168.1.2". In this case, your computer must have an
2
IP address in the range between "192.168.1.3" and "192.168.1.254".
Click Start > Run on your computer in Windows. Type "cmd" in the dialog box. Enter "ipconfig" to
3
show your computer's IP address. If your computer's IP address is not in the correct range then see
Appendix C on page 253
After you've set your computer's IP address, open a web browser such as Internet Explorer and
4
type "http://192.168.1.2" as the web address in your web browser.
Enter "1234" (default) as the password and click Login.
5
Type a new password and retype it to confirm, then click Apply. Otherwise, click Ignore.
6
The Easy mode appears. Click Expert Mode in the navigation panel.
7
To set your NBG4615 to Universal Repeater Mode, on the left of the screen, click Maintenance
8
> Sys OP Mode and select Universal Repeater Mode.
Figure 54 Changing to Universal Repeater mode
Note: You have to log in to the Web Configurator again when you change modes. As soon
as you do, your NBG4615 is already in Universal Repeater mode.
82
of this User's Guide.
for information on changing your computer's IP address.
Chapter 15 on page 125
NBG4615 User's Guide