Advanced - ZyXEL Communications NBG4615 User Manual

Chapter 19 DHCP Server
Figure 107 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 67 Network > DHCP Server > General
LABEL
Enable DHCP Server
IP Pool Starting
Address
Pool Size
Apply
Cancel

19.3 Advanced

This screen allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC addresses. You can also use this screen to configure the DNS server information that the
NBG4615 sends to the DHCP clients.
To change your NBG4615's static DHCP settings, click Network > DHCP Server > Advanced. The
following screen displays.
168
DESCRIPTION
Select the checkbox to enable DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132)
allows individual clients (computers) to obtain TCP/IP configuration at
startup from a server. Leave the Enable DHCP Server check box selected
unless your ISP instructs you to do otherwise. Clear it to disable the
NBG4615 acting as a DHCP server. When configured as a server, the
NBG4615 provides TCP/IP configuration for the clients. If not, DHCP service
is disabled and you must have another DHCP server on your LAN, or else the
computers must be manually configured. When set as a server, fill in the
following four fields.
This field specifies the first of the contiguous addresses in the IP address
pool for LAN.
This field specifies the size, or count of the IP address pool for LAN.
Click Apply to save your changes back to the NBG4615.
Click Cancel to begin configuring this screen afresh.
NBG4615 User's Guide