ZyXEL Communications NBG4615 User Manual page 93

Table 38 Status Screen: WISP Mode (continued)
LABEL
DHCP Table
Packet Statistics
Interface Status
Interface
Status
Rate
12.4.0.1 Navigation Panel
Use the menu in the navigation panel to configure NBG4615 features in WISP mode.
The following screen and table show the features you can configure in Access Point mode.
Figure 65 Menu: WISP Mode
Refer to Table 31 on page 69
NBG4615 User's Guide
DESCRIPTION
Click Details... to go to the Monitor > DHCP Table screen
this screen to view current DHCP client information.
Click Details... to go to the Monitor > Packet Statistics screen
Use this screen to view port status and packet specific statistics.
This displays the NBG4615 port types. The port types are: LAN and WLAN.
For the LAN and WAN ports, this field displays Down (line is down) or Up (line is up or
connected).
For the WLAN, it displays Up when the WLAN is enabled or Down when the WLAN is
disabled.
For the LAN ports, this displays the port speed and duplex setting or N/A when the line is
disconnected.
For the WAN port, it displays the port speed and duplex setting if you're using Ethernet
encapsulation and Idle (line (ppp) idle), Dial (starting to trigger a call) and Drop (dropping
a call) if you're using PPPoE or PPTP encapsulation. This field displays N/A when the line is
disconnected.
For the WLAN, it displays the maximum transmission rate when the WLAN is enabled and N/
A when the WLAN is disabled.
for descriptions of the labels shown in the Navigation panel.
Chapter 12 WISP Mode
(Section 6.5 on page 47). Use
(Section 6.6 on page 48).
93