General Wireless Lan 2.4G/5G General Screen - ZyXEL Communications NBG6515 User Manual

between APs is not encrypted. When WDS security is enabled, both APs must use the same pre-shared
key.
11.4 G e ne ra l Wire le ss L AN 2.4G / 5G G e ne ra l Sc re e n
Use this screen to enable the Wireless LAN 2.4G or 5G, enter the SSID and enable Guest WLAN.
Note: If you are configuring the NBG from a computer connected to the wireless LAN and you
change the NBG's SSID, channel or security settings, you will lose your WiFi connection
when you press
computer to match the NBG's new settings.
This screen varies depending on whether you chose
on the selected WiFi network. The WiFi clients which want to associate to this network must have same
WiFi security settings as the NBG.
authentication.
If you enable the WPS function, only
field.
Click
Ne two rk
Network > Wireless LAN 2.4G/5G > General
Fig ure 61
The following table describes the general wireless LAN labels in this screen.
Table 37 Network > Wireless LAN 2.4G/5G > General
L ABEL
Wireless Setup
Wireless LAN
Chapter 11 Wireless LAN
to confirm. You must then change the WiFi settings of your
Apply
No Se c urity
No Se c urity, Sta tic WEP, WPA- PSK a nd WPA2- PSK
> or
Wire le ss L AN 2.4G Wire le ss L AN 5G
DESC RIPT IO N
Select the radio button to
You can turn the wireless LAN on or off using the switch at the rear panel of the NBG.
NBG6515 User's Guide
Sta tic WEP, WPA- PSK o r WPA2- PSK
allows any client to connect to this network without
to open the
or
Ena b le Disa b le Wire le ss L AN
82
to add security
are available in this
screen.
G e ne ra l
.