PSD Sensor Assembly
1.
2.
3.
Note: Be careful not to lose shim (A) under the PSD sensor assembly. When you
reinstall the assembly, pull forward on tab (B) and install the front mounting screw first.
RIP Fan
1.
2.
3.
4.
4-34
Service Manual
Remove
"Printheads" on page
Remove the PSD sensor assembly mounting screws.
Disconnect the PSD sensor assembly cable and remove the assembly.
Remove the
"Top Cover" on page
Remove the rip fan mounting screws (A).
Disconnect the rip fan cable from the engine board at connector J53.
Remove the rip fan.
5060-XXX
4-33.
4-21.