Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 47

User Primary
Message
Calibrate <Tray x>
Load Paper
Tray x Not Calibrated
Change Cartridge
<Color> Invalid Refill
Change <custom Type
Name> <input source>
Change <input
source> <Custom
String>
Change <input
source> <Size>
Change <input
source> <type> <size>
5060-XXX
User Secondary Message Explanation
This message will be displayed when the user
has initiated a tray calibration procedure. <Tray
x> = Tray 1 thru 4, MPF, Envelope Feeder,
Manual Paper and Manual Envelope.
The following actions can be taken while this
message is displayed:
* Load paper into Tray x and press Go to initiate
the calibration.
* Press Menu> or Menu< to access the Busy/
Waiting Menu Group.
The following functions will be available via the
Busy/Waiting Menu:
* Reset Printer
* Reset Active Bin
* Check Supply Levels
This message will be displayed when a tray has
been detected that is uncalibrated. This message
usually means a user-correctable NVRAM
problem or the tray was not calibrated at the
factory or needs to be calibrated.
This message will be displayed when the printer
has detected a refilled prebate cartridge. <Color>
can be one of the following:
*Black, CYAN, Magenta or Yellow.
The following actions can be taken while this
message is displayed.
* Remove the toner cartridge and install a new
cartridge.
Note: The user will receive this message for
every invalid cartridge installed.
This message will be displayed when the printer
is requesting the operator to change the media
installed in one of the input sources. <input
source>=Tray 1 thru 5, MPF or Envelope Feeder.
One of the following will be displayed on line two.
* The user can define a name for each of the
custom types (Custom 1 thru 6)
Diagnostic Information
2-27