Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual page 49

User Primary
Message
Hole Punch Waste Full
Priming Failed, Retry.
GO/Stop
Insert Staple Cartridge
5060-XXX
User Secondary Message Explanation
This message will be displayed when the Hole
Punch Alarm is ON and any of the following is
true:
* The code has determined that the Hole Punch
Waste Box is completely full.
The following actions may be taken while this
message is displayed:
* The user may empty the Hole Punch Box and
put it back to clear the message.
* Press Go to ignore the message, the job will be
printed without hole punching.
Each time a new job that requests Hole Punch
will cause this message to be displayed again if
the box has not been emptied.
This message will be displayed when an error
has occurred during the printer staple priming
operation.
The following actions can be taken while this
message is displayed:
* Press Go to initiate the priming operation again
or
* Press Return or Stop to cancel the priming
operation.
Note: If no action is taken and the printer Auto
Continue setting is not disabled, the printer will
eventually clear the message and the priming
operation will be cancelled and the printer will
resume printing.
This message will be displayed when the staple
cartridge is missing or installed incorrectly. This
message can be displayed at any of the following
times, regardless of the Staple Alarm setting.
* At POST
* After the Stapler Door has been closed.
The following actions can be taken when this
message is displayed:
* Install the staple cartridge
or
* Press Go to ignore this message.
The printer will now handle staple jobs as if the
staple unit were installed with no staples. The
"Staples Empty" warning will appear on the status
line and "Load Staples" may immediately appear.
Diagnostic Information
2-29