Psd Sensor Assembly Removal - Lexmark C750 Service Manual

Installation notes
•
If a PSD exists, install the new printhead thermistor card. Leave the old PSD sensor assembly in place.
•
Disconnect the cable from the PSD card and connect it to the printhead thermistor card.
Note: Whether replacing a printhead thermistor or an existing PSD sensor assembly, check the Registration
and Color Alignment.
•
See "REGISTRATION" on page
•
See "Electronic color alignment" on page 4-58
•
See "Print line length calibration" on page

PSD sensor assembly removal

Note: Do not remove the PSD sensor assembly. Replace it with the printhead thermistor card and leave the
PSD sensor assembly in place. See
information.
3-14.
4-61.
"Printhead thermistor card removal" on page 4-62
5060-00x
installation
4-63
Repair information