Table of Contents
Advertisement
2-36
Chapter 2 - Description and Installation
DTIB-8/16
There is one 24 or 36-pin female amphenol connector labeled CONN3 located on the
front of the card. This allows the system to be cabled to the main distribution frame
(MDF). Pair telephone cabling must be prepared with mating connectors to extend the
inter-face circuits to the MDF. The cables should be routed through the cable clamps at
the bottom of the KSU to the MDF. These cables are then terminated on industry
standard 66M1-50 type punchdown connector blocks.
It is recommended that 66M1-50 split blocks with bridging clips be used to simplify
troubleshooting and to isolate faults.
DH S-L Instal lation
Advertisement
Table of Contents
