STARPLUS DHS-L Technical Manual page 160

3-90
Chapter 3 - Key Station Features, Operation, and Programming
To program a CO line button:
1. Select [dir].
2. Enter CO line or station number (201-272, 301-372). The display shows:
3. Press [save].
To program a system feature:
1. Press [FEAT ]. The display shows:
2. Press [FEAT ]. F will appear on the display:
3. Dial the feature code.
4. Press [save].
To erase the contents of a programmable feature button:
Press [save] instead of dialing a code.
Conditions
In some cases, a user may program a feature button for a specific CO line although
access is restricted to that line via system programming. In this situation, the
telephone is still governed by system programming and would still be unable to
access the CO line if restricted.
Valid feature codes must be in the form of either [F] + [n] or [F] + [nn] where F is the
feature button and n is either a 1-digit or 2-digit code, including asterisk [
pound [#] dialed from the dial pad.
Any feature button programmed with a code previously assigned to a different
feature button will cause the previously programmed feature button to become
unassigned.
D IR #
bksp save
FTR COD E: __
bks p s ave c h g
FTR COD E: F
bks p s ave c h g
If you dial an invalid code,you willhearerror tone andanExecutive Key Telephone display
will show CODE UNAVAILABLE.
c h g
Feature Button
] and
✳