Verifying Access To A Management Port; Verifying Management Port Connectivity; Setting Stack Management Preferences - Dell Force10 S2410-01-10GE-24P Configuration Manual

Verifying Access to a Management Port

It is possible to set the management VLAN to a VLAN that does not exist. If you cannot reach anything
from the management address, inspect the management VLAN with the commands
managementethernet
Figure 4-41.
Figure 4-41. Verifying Management Port Network
Force10 #show interface managementethernet
IP Address..................................... 192.168.0.50
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 192.168.0.11
Burned In MAC Address.......................... 00:01:E8:0D:30:9A
Locally Administered MAC Address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Network Configuration Protocol Current......... None
Management VLAN ID............................. 5
Web Mode....................................... Disable
Java Mode...................................... Disable

Verifying Management Port Connectivity

Figure 4-42. Verifying Management Port Connectivity
Force10 #ping 192.168.0.100
Send count=3, Receive count=3 from 192.168.0.100 Verify management port connectivity
Note: For more on management access, see
Loopback ACL on page

Setting Stack Management Preferences

For details on combining S-Series switches into virtual single switches through stacking commands, see
Chapter 5, Stacking S-Series
Note: Each model in the S-Series line is only capable of stacking with other switches of the
same model, and the S2410 models do not stack at all.
or show running-config , to inspect the management IP settings, as shown in
201.
Switches.
Protecting the Management Interface with a
show interface
Management | 69