Panasonic KX-T336 System Reference Manual page 608

1.02 OUS (Out of Service) command
Description
At the operationprompt (OPE>). enter the OUS
command to change the
status
of the target
device (shelf, card, station etc.) to "Out of
Service" in on-line mode.
Command Format
OPE> OUS + Item No. -;L.
(Item)
Refer to Section 15-E-3.00 7ST command (Test)
" for details about the test command.
Conditions
The status of target devices (shelf, card, station)
should be "INS," and the system must be in on-
line communication mode.
When you change the status of an upper device
(shelf, card), the status of lower devices (port,
station) change as follows.
Upper device
Lower device
INS +OUS
INS *OUS
Fault + Fault
Normal operation
When this operation
is executed
without failure,
"OPE>" initial prompt
appears again on the
screen.
Operation failed
An error message appears on the screen in the
torrowrng cases.
l
Parameter error
l
Not installed
l
Status error
If the system administration terminal is an
Attendant Console (ATT), do not change the
status of the following devices from 'INS" to
'OUS."
l
Shelf in which ATLC card is installed
l
ATLC card
l
Attendant console assigned as the
Maintenance Terminal
During remote operation, do not change the
status of the following devices from "INS" to
"OUS."
l
Shelf in which RMT card is installed
l
RMT card (Modem)
f
15-c-z