Panasonic KX-T336 System Reference Manual page 397

2.00 Error Messages Related to
the
Assigning Items in
the
Other Commands
If there is a wrong entry related to the assigned
by the other commands, the following appears on
the message line when stoning the entry:
&DATA
ERROR (xxx)."
The (XXX) indicates an error message number
shown below and possible causes of the errors
and countermeasures for them are as follows.
__.
-3
DATA
ERROR No.
300
Probable Cause Countermeasure
Setting DN which is not stored in the hundred
block.
301
302
Specified extension DN is not stored.
Telephone type of the extension paired with
DSS console is not PITS.
310 Setting DN to the DSS console.
320
I
330
331
I--
332
338
/
I
339
'\
t-
340
I
Enter data in hundred block. Or, set DN
which is stored in hundred block.
Store the extension DN.
Paired extension should be changed to a
PITS.
Setting trunk group except DID on CO-line on
DID card. Or, assigning trunk group of DID to
CO-line on the card except DID.
Set DN to assignable port.
Assign trunk group to the correct kind of
card.
Tenant is different.
As assigned to the destination of 1 : N of trunk
group, impossible to change tenant.
Assign the same tenant.
Cancel the 1 : N destination.
As assigned to the destination.of doorphone
call, impossible to change tenant.
Cancel the doorphone call destination.
. .
Setting one pickup group to ICM & PAG group
belonging to different tenant.
Changing tenant of ICfWPAG group without
canceling extensions.
Set it to the same tenant. Or, change tenant
after deleting pickup group.
Change after canceling extensions.
Impossible to move extensions to the other
tenant.
/
t.
As assigned to the destination of paging from
attendant console, impossible to change Tenani
Change the desti&tion of attendant paging:
As assigned to call placing mode of Trunk
group, impossible to change Tenant.
Change assigning of incoming mode.
As assigned to night answer point for CO-line,
impossible to change Tenant.
Change assignment of night answer point.
Attempting to change the tenant of Trunk group Change after removing the CO lines.
without removing the CO lines which belong to Impossible to move CO lines to the other
the
trunk group. tenant.
Attempting to change the tenant of Trunk group
without canceling the setting of 1 :N destination
for the trunk group.
Change after canceling 1: N destination.
Deleting is impossible because it is assigned in
another item.
Change the item beforehand.
1 O-D-2
(21292)