Panasonic KX-T336 System Reference Manual page 394

61.00 Waiting for Second Dial tone (WSD)
Description
In some areas, upon completion of area code entry, the extension user must
ensure the reception of the second dial tone from the central off ice before
continuing to dial the rest of the telephone number.
The WSD command is used to assign the area code and pause time
required to support the above mentioned special dialing procedures.
Refer to Section 3-F-12.00 Waiting for Second Dial tone" for further
information.
Proaramm
Register the facility access code required and pause time as
follows.
;PRG>WSDAT(J)
; Dial Entry Table No. 01
; 1 : Dial . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 811
; 2 : Pause . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
<Note>
(j) Dial
One through four digits number consisting of numeric characters 1 - 9
can be entered.
One character 'X' can be used as a wild card character that substitutes
any numeric character in its position.
(2) Pause
One digit (l-4) which indicates the number of pause characters.
A pause character may be used to help ensure the receipt of dial tone
from Central Office.
Each pause character causes a fixed dfafing delay of four and one-half
(4.5) seconds.
r
Up to four pause characters may be used consecutively, if a longer
pause is required.
Input Format
index Number
lnaex Number
Explanation
I
I
I
01 to 32 Dial Entry Table No.
1 o-c-1 03
(30393)
I