Panasonic KX-T336 System Reference Manual page 443

3.00 DSS (Direct Station Selection)
Button Assignment
Assigning various functions to the
DSS
buttons
on the KX-T30830 type PITS telephone and DSS
console is explained here.
The explanation of the message display applies
only
to a PITS provided with the display.
Operation
Result
Comment/Note
I. Set the MEMORY switch at
l
The following message
l
This status is called "initial
the rear of PITS to
appears on the display:
display for PITS station
"PROGRAM." programming mode."
L?!!!l
PITS-PGM No.?+
l
If the programming data of your
PITS has already been
SET. - PRoGRw
MEMORY
l
The MEMORY button indicator
accessed by another
lights in red.
administration device, the
following message appears on
the display.
Already Accessed
l
From now on in any status,
pressing the END button
restores this status.
!. Press a DSS button.
q
ifn
l
Previously stored data appears
l
If the following message
on the display.
appears, Message Waiting
<Example> If DSS(DN) feature
feature is already assigned
is assigned:
and changing the feature in this
mode is impossible.
DSS(DN):lOl 1
I
Message Waiting
l
The MEMORY button indicator
light goes out.
l
If nothing is entered within one
The associated DSS button
minute after pressing a DSS
indicator lights.
button, 'Initial display for
..r+.
qs- .4.*
PITS station programming
1. To change the stored data, mode" is shown on the display
dial the program number
again.
corresponding to the desired
feature.
l
To assign DSS (DN) feature, 1) The following message
1) Dial "1."
appears on the display:
•l
1
1 DSS(DN):
I
2) Dial a directory number 2) The dialed directory number
l
If the dialed
number does not
(three or four digits).
appears on the display: exist as a directory number,
alarm tone sounds
when
tas
4se
q
<Example> MEMORY
button is pressed.
7ll9
* [ DSS(DN):lOO
l
To clear an error entry, press
the
CLEAR button and
dial the
correct number.
12-C-l 1
Continued