Port Rate Control; Qos Control List - Draytek Vigor2130 Series User Manual
High speed gigabit router
Hide thumbs
Also See for Vigor2130 Series:
- User manual (296 pages) ,
- Quick start manual (41 pages) ,
- User manual (39 pages)
Table of Contents
Advertisement
3
.
4
.
3
P
o
r
t
R
a
3
.
4
.
3
P
o
r
t
R
a
A policer can limit the bandwidth of received frames. It is located in front of the ingress queue.
And a shaper can limit the bandwidth of transmitted frames. It is located after the ingress
queues. This page allows you to configure the switch port rate limit for Policers and Shapers.
Port
Policer Enabled
Policer Rate(Rx)
Policer Unit
Shaper Enabled
Shaper Rate (Tx)
Shaper Unit
3
.
4
.
4
Q
o
S
C
o
3
.
4
.
4
Q
o
S
C
o
Deploying QoS (Quality of Service) management to guarantee that all applications receive the
service levels required and sufficient bandwidth to meet performance expectations is indeed
one important aspect of modern enterprise network.
One reason for QoS is that numerous TCP-based applications tend to continually increase their
transmission rate and consume all available bandwidth, which is called TCP slow start. If
other applications are not protected by QoS, it will detract much from their performance in the
overcrowded network. This is especially essential to those are low tolerant of loss, delay or
jitter (delay variation).
Another reason is due to congestions at network intersections where speeds of interconnected
circuits mismatch or traffic aggregates, packets will queue up and traffic can be throttled back
to a lower speed. If there's no defined priority to specify which packets should be discarded
(or in another term "dropped") from an overflowing queue, packets of sensitive applications
mentioned above might be the ones to drop off. How this will affect application performance?
There are two components within Primary configuration of QoS deployment:
Classification: Identifying low-latency or crucial applications and marking them for
high-priority service level enforcement throughout the network.
Vigor2130 Series User's Guide
t
e
C
o
n
t
r
o
l
t
e
C
o
n
t
r
o
l
Represent LAN or WAN interface.
Check this box to enable policer function.
Type the number for policer function. The default value is 500.
It is restricted to 500-1000000 when the Policer Unit is set in
kbps, and it is restricted to 1-1000 when the Policer Unit is set
in Mbps.
Determine the unit (kbps/Mbps) for policer.
Check this box to enable shaper function.
Type the number for shaper function. The default value is 500.
It is restricted to 500-1000000 when the Shaper Unit is set in
kbps, and it is restricted to 1-1000 when the Shaper Unit is set
in Mbps.
Determine the unit (kbps/Mbps) for shaper function.
n
t
r
o
l
L
i
s
t
n
t
r
o
l
L
i
s
t
59
Advertisement
Table of Contents
