Draytek Vigor2130 Series User Manual page 156

Choose IPv4 as the Frame Type. You will see IP Parameters on the bottom of the page.
If you choose Other as IP Protocol Filter, you will get the page as the following:
IP Protocol Value
Source IP
Source IP Address
Source IP Mask
Dest IP
1: TCP frames where the URG field is set must be able to
match this entry.
Any: Any value is allowed.
When "Other" is selected for the IP protocol filter, you can
enter a specific value here. The range is 0 to 255. The
default value is "255".A frame meeting this ACE matches
this IP protocol value.
Specify the source IP filter for this ACE.
Any: No source IP filter is specified.
Host: Source IP filter is set to Host. Specify the source IP
address in the source IP Address field that appears.
Network: Source IP filter is set to Network. Specify the
source IP address and source IP mask in the source IP
Address and source IP Mask fields that appear.
Type the source IP Address here. This option is available
when you choose Host or Network as source IP Filter.
Type the source IP Mask here. This option is available
only when you choose Network as source IP.
Specify the destination IP filter for this ACE.
Any: No destination IP filter is specified.
Host: Destination IP filter is set to Host. Specify the
destination IP address in the destination IP Address field
that appears.
Network: Destination IP is set to Network. Specify the
destination IP address and destination IP mask in the
148
Vigor2130 Series User's Guide