Draytek Vigor2130 Series User Manual page 103

When TSPC configuration has been done, the router will start to connect. The connecting page
will be shown as below:
When the router detects all the information, the screen will be shown as follows. One set of
TSPC prefix and prefix length will be obtained after the connection between TSPC and
Tunnel broker built.
Connection Status
Tunnel Information
Tunnel Status
Activity
Vigor2130 Series User's Guide
It will bring out different pages to represent IPv6
disconnection, connecting and connected.
Display interface name (used to send TSPC prefix), tunnel
mode, local endpoint addresses, remote endpoint address,
TSPC Prfix, TSPC Prefixlen (prefix length), tunnel broker
and so on.
Disconnected - The remote client doesn't connect to the
tunnel server.
Connecting - The remote client is connecting to the tunnel
server.
Connected – The remote client has been connected to the
tunnel server.
Sent - sent to the tunnel (RX bytes).
Received - received from the tunnel (RX bytes).
95