Ports - Draytek Vigor2130 Series User Manual

Modem Dial String
PPP Username
PPP Password
Clone MAC Address
After finishing all the settings here, please click OK to activate them.
4 . 1 . 2 P o r t s
4 . 1 . 2 P o r t s
Ports page is used to change the setting for WAN port. You can set or reset the following
items. All of them are described in detail below.
Port
Link
Current
Speed Configured
Flow Control
Vigor2130 Series User's Guide
Such value is used to dial through USB mode. Please use the
default value. If you have any question, please contact to your
ISP.
Type the PPP username (optional).
Type the PPP password (optional).
It is available when the box of Enable is checked. Click Clone
MAC Address. The result will be displayed in the field of
MAC Address.
It displays current network interface.
It displays current connection status. Green light means the
WAN connection is successful.
It displays current speed that the router uses.
You can use the drop down list to choose the required speed for
the router. If you have no idea in configuring speed, simple use
the default setting, Auto.
If flow control is enabled by checking Configured box, both
parties can send PAUSE frame to the transmitting device(s) if
the receiving port is too busy to handle. If not, there will be no
flow control in the port. It drops the packet if too much to
handle.
Current Rx: indicates whether pause frames on the port are
obeyed.
117