Table of Contents
Advertisement
Remote Telnet Connection
If properly set up, the AP support prompt can be accessed remotely using
Telnet. By default, this feature is turned off for security purposes and cannot
be turned on using the AP interface.
Setting Telnet Access
Telnet access can only be changed from the Wireless LAN switch
management interface. Log in to the Wireless LAN switch CLI using the admin
account, access the configuration (config) prompt, and issue the following
commands:
(OmniAccess AP6000) (config) # ap location <building>.<floor>.<device>
(OmniAccess AP6000) (sap-config location b.f.d) # telnet
{enable|disable}
Using Telnet to Connect
Use a Telnet client on your management workstation to connect to the
OmniAccess AP60/61's individual IP address. The connection command may
vary depending on the specific software used, but commonly appears as
follows:
> telnet <OmniAccess AP60/61 IP address>
When the connection is established, the AP support prompt (#) will be
displayed.
Appendix B
Troubleshooting
41
Advertisement
Table of Contents
