Table of Contents
Advertisement
OmniAccess AP60/61: Installation Guide
2
When prompted, log in to the Wireless LAN Switch as the administrator:
user: admin
password: <administrator password (not displayed)>
This will present you with the Wireless LAN Switch SOE console prompt:
Available commands:
baud [9600|19200|38400|57600|115200]
connect <slot/port>
exit (no args)
soe>
3
Connect to the Wireless LAN Switch port to which the OmniAccess
AP60/61 is physically attached:
connect <slot number>/<port number>
soe>
where slot number is the physical slot of the line card in the Wireless LAN switch,
and port number is the physical port.
If the AP has not finished booting, allow the Autoboot timer to expire. When
the device has booted, the AP support prompt (#) will appear.
Direct Terminal Connection
This method requires that the OmniAccess AP60/61 is connected to a
compatible serial console using the Alcatel serial breakout adapter (see
"Connecting the Console Terminal"
1. Set up your local terminal.
This procedure requires a terminal or computer running terminal emulation
software with the following settings:
Baud Rate
9600
2
Establish console communication.
Press <Enter> a few times to establish communication between the
OmniAccess AP60/61 and terminal.
If the AP has not finished booting, allow the Autoboot timer to expire. When
the device has booted, the AP Support prompt (#) will appear.
40
Part 031643-00 Rev. 01
T
3-2 Console Terminal Settings
ABLE
Data Bits
8
on
page
16).
Parity
Stop Bits
None
1
Flow Control
None
June 2005
Advertisement
Table of Contents
