Table of Contents
Advertisement
OmniAccess AP60/61: Installation Guide
7
The Clear Table button appears after an entry in the list appears.
To erase all the table entries, click Clear Table. (You cannot clear selected
entries.) If a number of APs are provisioned and you click Clear Table, only the
entries which come up afterwards can be provisioned.
If the entry does not show up in the AP list, check network connectivity. Go to
the AP console and verify if the AP has come up with the IP from the
provisioning subnet.
8
After the entry shows up on the page, configure the location, Host
IP/Name, Master IP address.
If AP is going to be assigned a static IP , click Use the following IP Address and
enter the IP address, Netmask, Gateway IP .
If the AP is going to obtain an IP address using DHCP , click Use IP Address
Using DHCP .
9
After configuring the required parameters, select the entry from the list (AP
to which the configuration has to be applied) and click Apply.
The State field changes from U (Unprovisioned) to In Progress. to P
(Provisioned).
—Check that the configured parameters are reflected in the AP list entry.
N
OTE
—Alcatel recommends that you provision each AP for a unique location as suggested by site-sur-
N
OTE
vey planning. Label each AP with this location information and place the AP in its proper location.
Failure to place APs in the location for which they were provisioned will reduce the effectiveness of
such RF features as triangulation.
10 Click Back to return to the previous page
We can see that the Subnet is still configured and Port/s are selected.
11 When finished provisioning APs, click Disable to disable AP Provisioning.
—Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for
N
OTE
provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still set to
provisioning mode will prevent that AP from functioning.
Now the AP is configured with the Parameters given
12 Reboot the AP so the AP will come up with the new configured
parameters.
Use the Reprovisioning tab for APs which are already deployed but need to be
reconfigured. See the AOS-W User Guide for information on reprovisioning.
14
Part 031643-00 Rev. 01
June 2005
Advertisement
Table of Contents
