Table of Contents
Advertisement
Antenna fixtures for Wireless Communications
1
Depending on the model, the AP will have one of the following:
A
OmniAccess AP60–Two Reverse Polarity SMA (RP-SMA) connectors for
attaching separate antennas (not included). For details, see
Detachable Antennas"
used in AOS-W 2.2 releases or lower. Single antenna operation is supported
with AOS-W 2.3 or higher.)
N
—When facing the AP60 as shown in
OTE
right is for antenna 1, and the connector on the left is for antenna 2 in a diversity
configuration.
B
OmniAccess AP61–Built-in swivel array with dual, tri-band, omnidirectional
antennas
2
Indicator LEDs
During operation, the OmniAccess AP60/61 LEDs provide the following
information:
T
ABLE
LED
State
A
PWR
Off
Green-Solid
B
ENET
Off
Green-Solid
Green-Flashin
g
C
Wireles
Off
s LAN
Green-Solid
Green-Flashin
g
N
—LEDs on the Wireless LAN Switch provide additional status and secu-
OTE
rity information about connected APs.See the Alcatel AOS-W User Guide for
more information.
on
page
26. (The AP60 requires that both connectors be
1-1 OmniAccess AP60/61 LEDs
Description
The device is off - no power.
The device is powered and operating.
No link on the FE port. No connection to the
network.
Ethernet link detected on the FE port.
Transmitting or receiving data across the FE
port. Flashing rate is proportional to network
activity.
The wireless interface is disabled or down.
The wireless interface is enabled and
functioning as an Access Point.
The wireless interface is enabled and
functioning as an Air Monitor.
"OmniAccess AP60
Figure
1-1, the antenna connector on the
Chapter 1
Introduction
3
Advertisement
Table of Contents
