Table of Contents
Advertisement
—The master and serverip environment variables also affect how source files
N
OTE
are selected and should be cleared when using this approach. To clear a variable,
enter the setenv variable command with no host or address value.
When finished, proceed to Step 2.
My network uses direct IP addresses instead of DNS.
If using direct IP addresses in your network, use the following com-
mands:
apboot> setenv serverip <Wireless LAN switch IP address>
apboot> setenv master <Wireless LAN switch IP address>
—If the servername variable is configured in this scenario, it will be ignored.
N
OTE
2 Specify an IP address for a specific AP , if necessary.
If using DHCP , the AP will obtain its IP address automatically and you can skip
this step. Otherwise, configure the AP with a static IP address using the
following commands:
apboot> setenv ipaddr <static IP address for the AP>
apboot> setenv netmask <static IP address mask>
apboot> setenv gatewayip <default gateway IP address>
3 Set the location for the specific AP , if necessary.
Location settings depend on how much control you want over configuring
logical groups of APs in the future.
Default Locations
If you wish all APs treated as a single entity for configuration and
accounting purposes, you can use the default location profile
(255.255.65535) and skip to Step 5.
N
—If using default locations during initial provisioning, you can later reconfigure
OTE
the APs to use specific location IDs using the OmniAccess Wireless LAN Switch
management tools.
Chapter 2
Provisioning Access Points
21
Advertisement
Table of Contents
