OmniAccess AP60/61: Installation Guide
The OmniAccess AP60/61 can be mounted on a wall or suspended from
above (not shown) using one of the optional mounting kits (dimensions
vary) in the following ways:
1
N
—For dimensions, see
OTE
space on the right-hand side for cables. Measurements for the OmniAccess 60
depend on attached antennas, which vary.
OmniAccess AP60 Detachable Antennas
Before deploying the OmniAccess AP60, attach the appropriate antennas (not
included). The antenna connections should be tightened by hand to avoid
overtightening.
The OmniAccess AP60 has dual Reverse Polarity SMA (RP-SMA) female
antenna connectors that accept a variety of high-gain detachable antennas.
See
Table 3-1
OmniAccess AP60.
Make sure that all external antennas and their associated wiring are located
entirely indoors. The OmniAccess AP60 Access Points and their optional
external antennas are not suitable for outside use.
26
Part 031643-00 Rev. 01
F
3-1 OmniAccess AP60/61 Mounting Options
IGURE
"Product
for the list of FCC approved antennas tested for use with the
2
Specifications". Allow 5 cm (2") additional
3
June 2005