Table of Contents
Advertisement
OmniAccess AP60/61: Installation Guide
5 Set your local terminal to use the following communications:
Baud Rate
9600
6 Establish console communication.
Press <Enter> a few times to establish communication between the
OmniAccess AP60/61 and terminal.
7 From the OmniAccess AP60/61 console, access the apboot
prompt.
Depending on the OmniAccess AP60/61 status, you will see one of the
following on your terminal:
Autoboot countdown—The countdown prompt allows you to interrupt the
normal startup process and access the apboot prompt where provisioning is
performed.
APBoot 1.2.1 (Apr
CPU:
AR2313 MIPS-32 at 180 MHz: 16 kB I-Cache 16 kB D-Cache
Board: Merlot Local Bus at 90 MHz
DRAM:
32 MB
POST:
passed
FLASH: 4 MB
Net:
en0 lo0
Hit any key to stop autoboot:
To access the apboot prompt, press any key (such as <Enter>) before the timer
expires. If the countdown expires before you can interrupt it, turn the device off
and then back on.
18
Part 031643-00 Rev. 01
T
2-1 Console Terminal Settings
ABLE
Data Bits
8
7 2004 - 08:54:57)
Parity
Stop Bits
None
1
0
Flow Control
None
June 2005
Advertisement
Table of Contents
