Table of Contents
Advertisement
F
IGURE
5
Specify the OmniAccess 60/61-specific parameters.
Configure the gain value appropriate for the location in which this AP will be
deployed. (See
Table 3-1
—If the AP being provisioned is a model with detachable antenna capability (such as an Omni-
N
OTE
Access AP-60) enter the antenna gain in dBi, for example 4.0. This is mandatory for all detachable
antenna models as the AP will not will bring up its radio interface or function as an AP without it.
Complete specifying Master Discovery and IP Settings and click
6
Plug the AP into one of the ports configured for provisioning.
If your AP is already plugged into the port, unplug it and plug it in again.
If AP is connected through POE, enter (in interface mode) no poe followed by
poe.
The AP will come up with an IP from the provisioning subnet
After the AP comes up it should be in the provisioning list. Provisioning list
shows the list of APs which are plugged into the provisioning ports.
2-2 Port Range Screen
for appropriate antenna gain values.)
Chapter 2
Apply
.
Provisioning Access Points
13
Advertisement
Table of Contents
