Using The Built-In Mounting Slots - Alcatel-Lucent OmniAccess AP60 Installation Manual

OmniAccess AP60/61: Installation Guide

Using the Built-In Mounting Slots

The keyhole-shaped slots on the back of the OmniAccess AP60/61 can be
used to attach the device upright to an indoor wall or shelf.
C
AUTION
ceiling, sideways, or in any place where it could fall on people or equipment. For more
secure installation, use one of the optional mounting kits.
To hang the OmniAccess AP60/61 upright using the mounting slots, perform
the following steps.
1 Install two screws in the wall or shelf as shown in
Screw/Nail Positions
(fastened to wall or shelf)
12.7 cm
If attaching the device to drywall, we recommend using appropriate wall
anchors (not included) as shown in
30 Part 031643-00 Rev. 01
—Do not use the mounting slots to hang the OmniAccess AP60/61 from the
(5.00")
F 3-3 Mounting Screw Specifications
IGURE
Screw/Nail Dimensions
Maximum Minimum
7.0 mm
5.8 mm
2.0 mm
3.8 mm
clearance
from surface
3.0 mm
0.27"
0.23"
0.08"
0.15"
clearance
from surface
0.12"
Figure 3-4 on page 31.
Figure 3-3:
1.3 mm
clearnace
from surface
0.05"
clearance
from surface
June 2005