Table of Contents
Advertisement
Colored Messaging
Note: This is a system dependent feature for 5604 Services license only.
It is possible to send colored messages to handsets. The sender of a message (that is, an
application) determines the color of the message. Colored messaging can be useful for
categorizing messages. In figure 8, there are two colored messages (a new message, and a
read message) in the message inbox (left in the figure). The messages are indicated by a
gradient color bar behind the envelopes. When reading a message, a gradient color bar is
shown below the envelop (right in the figure).
To enable colored messaging, see the corresponding manual for the application used. In
addition, colored labels can be mapped to message beep codes. See IP-DECT WSM
Installation and Operation Manual.
Mobile Data
Note: This is a system dependent feature for 5604 Services license only.
Send Mobile Data
It is possible to send user entered data from the handset by pressing a pre-programmed Hot
key or Soft key, or selecting a Service. Mobile data can be used for opening a door,
starting/stopping a machine etc. The data can either be predefined, or entered after the Hot
key/Soft key is pressed or Service is selected.
The data can be predefined when programming the Soft/Hot key or Service, see Define Soft
Keys on page 54, Define Hot Keys on page 54, or Add Services on page 56.
Send Mobile Data with a Prefix
Mobile data with a prefix is sent from the handset by entering data and then pressing a
pre-programmed Hot key or Soft key or select a Service. Mobile data with prefix can be used
to send information to an application in the system.
12:34
Inbox
Patient ready...
2009-01-01
Patient ready...
2009-01-01
View
More
Back
Figure 8: Shows an example of a colored message
5604 Wireless Handset User Guide
12:34
2009-01-01 12:00
Patient ready for transport.
From: X-ray
To: B/12/3
Call
Help
Reject
33
Advertisement
Table of Contents
