Table of Contents
Advertisement
5604 Wireless Handset User Guide
Error or Warning Messages
Display shows
No access
No System. The handset
beeps once a minute
(during max 30 minutes)
with a low tone followed
by a high tone (if enabled,
the vibrator also follows
the beeps).
SERVICE NEEDED
Parameters corrupt
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown in
English.
Enter PIN code
Battery low, charge now
Phonebook is not
available at the moment.
Voice mail number not
defined
Could not encrypt
connection.
72
Probable cause
The network is in range, but no
access rights.
The handset is out of coverage or
handset is defective.
The handset is defective.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
The handset's lock is activated.
The battery level is low.
The phonebook does not respond, not
available at the moment.
There is no Voice mail number
defined in the handset.
The parameter "Encryption Required"
is enabled in the handset in
combination with;
1. Unencrypted base station(s);
and/or,
2. Unsupported base station(s).
Action or comment
Switch handset off and then switch
it on again or contact system
administrator.
Stop the beep with the Sound off
key and go into range.
Note: When re-entering the
coverage area it can take a couple
of minutes before the handset
automatically has registered into
the system.
or
contact system administrator.
Select reset option on the middle
soft key if available or if no reset
option is available or fault does not
resolve the handset needs repair.
Note: Display message only
shown in English.
Send the handset for service.
Enter the required PIN code. If PIN
code lost enter new via PDM or do
a factory reset via PDM.
Charge or replace the battery.
Try again later or if fault persists do
a factory reset via admin menu or
PDM.
Define a Voice mail number via
PDM.
1. Disable the "Encryption
Required" parameter in
handset; and/or,
2. Enable the encryption in the
base station(s); and/or,
Note: If base station(s) is used,
the software version must be
3.1.x or later.
3. Use supported base station(s).
Ask your supplier.
Advertisement
Table of Contents
