Table of Contents
Advertisement
Easy Replacement Procedure
During the Easy Replacement procedure, the LEDs of the handset and the charger follow the
same LED indications. This means that if the old handset has a broken display, the LED
indications on the charger and on the handset can be used to follow the replacement procedure.
Before and after easy replacement, the LEDs may have different LED indications. For more
details, see LED Indications during Easy Replacement on page 78.
IMPORTANT:Never remove a handset from the charger until the instructions in the
display or the LED tells you to do so (see status on the LED if the display is broken). If
there is an error indication it may be allowed to remove the handset, see Troubleshooting
on page 71 for further instructions.
After the old handset has been in the charger, the new handset needs to be placed in
the charger regardless if the replacement was successful or not. Failing to do so may
result in malfunction and the new handset will need to be sent for service.
New
1
Figure 11: Easy Replacement via 5603/4 Programmer
1
On the new handset, press and hold
Note: Do not release
2
Put the new handset in the charger.
3
When the text "Start phone replacement?" is displayed, release
Press "Yes" (left soft key).
The text "Follow the instructions. Each step can take several minutes." appears in the display.
Press "OK"(left soft key).
New
2
3
until you are instructed to do so.
5604 Wireless Handset User Guide
New
Old
4, 8
7
5
6
.
77
Advertisement
Table of Contents
