Error Messages And Their Meanings - Savin 2045 Facsimile Reference Manual

Troubleshooting

Error Messages and Their Meanings

If there is an error, one of the following messages may appear on the display. It
might just flash briefly, so if you are watching for errors, stay by the machine and
check the display.
Message
Put original back, check it and press the { { { { Start} } } }
key.
Error occurred, and transmission was can-
celed.
4
Cannot detect original size. Place original
again, then press [Start].
L Call Service
Functional problems with facsimile. Please call
service.
Memory is full. Cannot scan more. Transmit-
ting only scanned pages.
Following output tray is full. Remove paper.
Cannot scan to send fax message as scanner is
in use for other function.
Updating the destination list.
Please wait. Selected destinations or function
settings have been cleared. Please reselect after
the update finishes.
50
Causes and solutions
Original jammed during Memory Transmis-
sion. Place originals that have not been
scanned again.
A document jam occurred during Immediate
Transmission. Press [OK], and then resend the
pages that have not been sent.
An error occurred during Immediate Trans-
mission. Press [OK], and then resend the origi-
nal.
Note
❒ There may be a problem with the machine
or the telephone line (for example noise or
cross talk). If the error reoccurs frequently,
contact your service representative.
The machine failed to detect the size of the
original. Place originals again, and then press
the { { { { Start} } } } key.
There is a problem with the fax. Record the
code number shown in the display and contact
your service representative. The copy function
will still work normally.
If you press [OK], the machine returns to stand-
by mode and starts transmitting the pages that
have been scanned.
The paper output tray is full. Remove paper
from the tray indicated in the display.
The Copy or Document Server function is in
use. To cancel the job in process, do the follow-
ing, and then try faxing again.
Press [Exit], and then press the { { { { Copy} } } } or { { { { Doc-
ument Server} } } } key. Next press the { { { { Clear/Stop} } } }
key. When the message "[Stop] key was
pressed. Stop copying?" or "[Stop] key was
pressed. Stop storing?" appears, press [Stop].
Wait with the main power switch on. The ma-
chine will enter standby mode after it exits
from RDS mode.