Placing A Single Original On The Exposure Glass - Savin 2045 Facsimile Reference Manual

Faxing
Note
❒ When sending a fax, the image
output at the other end depends on
the size and orientation of paper
used in the receiver's terminal. If
the receciver does not use paper of
the same size and orientation as
2
that of the original, the fax image
may be reduced in size, trimmed at
both edges, or divided into two or
more sheets. When sending an im-
portant original, we recommend
you ask the receiver about the size
and orientation of the paper used
in their terminal.
❒ When sending an original of irreg-
ular (i.e. custom) size or part of a
large original, you can specify the
scan area precisely. See p.14 "Set-
ting a Scan Area".
❒ C u s t o m s iz e d o c u m e n t s a r e
scanned as regular size documents,
so the receiver may find extra blank
margins or edges of images miss-
ing. If you specify a scan area, only
that area will be scanned regardless
of actual document size.
❒ Make sure that all ink, correcting
fluid etc., has completely dried be-
fore placing your original. If it is
still wet, the exposure glass will be
marked and those marks will ap-
pear on the received image.
❒ If you place an A4 size original in
the portrait orientation, the ma-
chine rotates the image by 90 de-
grees before sending. See p.73
"Transmission with Image Rota-
tion", Facsimile Reference <Ad-
vanced Features> .
❒ You can send the first pages from
the exposure glass then the re-
maining pages from the ADF. Af-
ter you have removed the last page
from the exposure glass, insert the
remaining pages in the ADF, and
then press the { { { { Start} } } } key.
12
Reference
F o r h o w t o p l a c e t w o - s i d e d
documents, see p.56 "Two-Sided
T ra n s m i s s i o n (D o u b l e - S i d e d
Transmission)", Facsimile Reference
<Advanced Features> .
Placing a Single Original on
the Exposure Glass
Place originals that cannot be placed
in the optional Auto Document Feed-
er (ADF), such as a book, on the expo-
sure glass one page at a time.
A A A A
Lift the exposure glass cover or
the ADF by at least 30 degrees.
Note
❒ If you do not lift the ADF by at
least 30 degrees, the original
size will not be detected.
B B B B
Place the original face down and
align its upper left corner with the
reference mark at the upper left
corner of the exposure glass.
1.
Positioning mark
2.
Scale